I have a question about an amp

[Grump]

I got a bruiser 100watt amp today it shows a remote plug but it didn't come with a remote can anyone tell me how to take it out and put in a switch. here are some pics of the inside

[Ricky]

usually there are 2 wires on the remote jack, jus put a switch in line. it should work

['Doc]

Looks like there are at least three wires on that jack. Is it supposed to switch between power levels? Maybe a pre-amp? Some other feature that you can turn on/off? I think I'd go back to where ever it came from and 'whine', 'snivel', 'cry' till I got the remote. Or at least a schematic or an explanation.
- 'Doc

Psst - that 'whine'/'snivel'/'cry' thingy really works if you're under 12 y.o. or ever 60! Been field testing it at Wal-Mart...

[Grump]

there is four wires to the remote connector I wish i could i bought it in a lot with 10 other radios The old guy i got it from bough it at an estate sale so he was no help

[Grump]

it is also for ssb could two wires befor power and the other two be to turn it on to the ssb

[Grump]

Well I'm just about ready to strip it down for parts can't find anything about them anywhere I guess it was a peice of junk and no one bought them

[lonesome 500]

hang tight .i'm looking

tracing it

follow from red pwr wire....it will trace to remote jack....other will go to relay

find the 2 for pwr first

ps...if you didn't get the remote....they are easy to replace..4 pin mic jack work great

[Grump]

this one is more than four pin its a nine pin but only uses four

[Grump]

does anyone know whats inside a remote for an amp and I'll build one just need to know if it is wires or a circut board my amp is a class ab for ssb any help is greatly appriciated

[lonesome 500]

nothing more than switched wires grump

[270inVA]

I just got the same amp its a Bruiser amp only diff it mine has a 2nd small board inside on the wall it has two wires that go to the remote plug in and it even has its own relay!! ill post pics asap cant now no phone...but anyone no how to wire a remote up or would it be better to put it on a switch??thanks for the help

-- Wednesday, 06 August 2014, 8:04 AM --

o forgot but the is a switch on the front for the preamp...

[MDYoungblood]

The amp that is pictured has 4 connections, I would venture to say two wires are for a pre-amp or SSB delay and the other to are to turn it on. If your amp only has two wires going the remote jack, it is an open circuit (off) just make a cable with a SPST toggle switch, closing the circuit turns the amp on. To make sure I'm right a pic or two would help.

3's

Greg

[Flash Gordon]

pin 1 is ground.
pin 7 is amp control, when put to ground, amp will not function.
pin 8 is ssb timing, when put to pin 7, relay has a delay.
pin 4 is 13.8 volts.