RF gain problem
- bluecurt49
- 4 PILL USER
- Posts: 21
- Joined: February 28th, 2016, 9:11 am
RF gain problem
I have a connex 3300hp and the rf gain knob don't change the noise none ive changed the pot and transistor checked the resistors and it hasnt helped any ideas
- jessejamesdallas
- Donor
- Posts: 6,284
- Joined: October 10th, 2004, 7:02 pm
- Handle: Jesse James Dallas
- Real Name: Jesse
- Radio: working
- Contact:
Re: RF gain problem
Is this a New radio? Someone could have added a Variable Power in place of the RF Gain and just set the RF Gain to wide open...Check your DK and see if it changes when you adjust the knob.
Do not argue with an idiot. He will drag you down to his level and beat you with experience.
- MDYoungblood
- Site Admin
- Posts: 10,740
- Joined: June 12th, 2010, 8:05 pm
- Handle: MDYoungblood
- Real Name: Gregory
- Antenna: HyGain AV-6160
- Radio: Icom IC-746 (non pro)
- Contact:
Re: RF gain problem
The RF gain doesn't reduce any noise just the receive signal, does the signal meter drop when you turn the knob to the left?
3's
Greg
3's
Greg
"321, West Manchester Township, PA"
Official Moderator - CBRT Complaint Department
- bluecurt49
- 4 PILL USER
- Posts: 21
- Joined: February 28th, 2016, 9:11 am
Re: RF gain problem
it does not change anything and it is an connex3300 side mic. its an old radio
- bluecurt49
- 4 PILL USER
- Posts: 21
- Joined: February 28th, 2016, 9:11 am
Re: RF gain problem
what would cause it to quit working
- sonoma
- Donor
- Posts: 1,459
- Joined: April 2nd, 2006, 3:10 pm
- Handle: sonoma
- Real Name: sonoma
- Radio: President Washington
- Contact:
Re: RF gain problem
trace the wires where they solder to the main board and verify they are making good connection. you could have a bad solder joint in the area where the wires hookup causing it not to change. get your magnifying glasses on with a solder gun and start checking for a bad solder joint. even look at the caps in that area since you said it is a old radio. you may have some of them failing. look on cbtricks.com under connex and they have a picture of the main board for active devise locations. this will also help you look at each part location. I bought a galaxy 44hml whish is a old radio on ebay for next to nothing because it did not work properly and it had bad solder joints in the vco PLL areas. works great now.
- bluecurt49
- 4 PILL USER
- Posts: 21
- Joined: February 28th, 2016, 9:11 am
Re: RF gain problem
the problem was fixed the ground wire on the switch was in the wrong place on the switch
- sonoma
- Donor
- Posts: 1,459
- Joined: April 2nd, 2006, 3:10 pm
- Handle: sonoma
- Real Name: sonoma
- Radio: President Washington
- Contact:
Re: RF gain problem
glad you found it. just takes time to trace out the wires and the locations plus bad solder joints on most radios.