how to adjut deadkey or install a variable new general lee

[517 squirrel]

ok most things i can figure out by searching but haven't found anything on the new general lee's on adjusting the deadkey. just wantin to make sure i get the right pot cause its too high it was set at 2 watts on a power supply when it was fixed up but i put it in my truck and its a 5 watt deadkey. not good for my 2x4. i'm not opposed to putting in a variable just point me in the right direction plz.

[genesbro]

Look on cbtricks.com under the galaxy dx33hml or the connex 3300, I think those have the same layout as the general and will show where the pots are. There are two one for low and one for high.

[517 squirrel]

thank ya for the help every little bit helps i was just wantin to make sure they didnt change any of the turn pot numbers when they went to dual mosfets